Brady 1024 Manual del operador descargar pdf (Pagina 61)

Skips every other label

(Print quality is good but skips every other label).

 The label is formatted too close to the top edge of the form.

Leave white space equal to 8-dot rows at the top of the label,

approximately .02" (.5mm).

 The media is not calibrated (see Chapter 4).

 If equipped, the Adjustable Media Sensor may need to be

repositioned (see Chapter 3).

 The media sensor or media sensor circuitry may be

defective, call for service.

Unable to print in rotation 4

 The characters are formatted outside the dimensions of the

label. Check that the row/column values provide enough

room for the height of the characters or bar code to be

printed.

Prints light on the right side of the label

 The media width adjustment is set for a narrower media

width than is actually being used (see Chapter 5).

 The printhead is not properly aligned, call for service.

 The printhead is not locked down.

Printer fails to turn on

 A fuse may be blown, call for service.

 Faulty power supply, replace.

 A bad power switch may exist on the printer, call for service.

 A faulty AC wall outlet.

BP-1244/BP-1344 51

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 81 82

Sin comentarios

Brady 1024 Manual del operador Pagina 61