Brady THT-BP Precision Manual del operador descargar pdf (Pagina 127)

F-3Transfer Printer THT-BP Precision

Error Messages During the Firmware Update

In the event an error occurs during the updating process, the error code will be

displayed on the LCD:

'C' : Check sum error (possibly "/b" missing in COPY command or

a corrupt firmware file)

'H' : Header fault (possibly "/b" missing in COPY command or a

corrupt firmware file)

'E' : EPROM could not be erased

'V' : Programming voltage too low

'P' : Programming fault

NOTICE !

If any one of the faults described above occurs, the previous firmware

setting is invalid and the update has to be started again. In some special

cases, it is possible that the printer will not return to normal operation

mode after powering on after a failed firmware update. In this case,

upload a previous firmware file over the parallel interface after powering

on.

Appendix F - Firmware Updates

1 2 ... 122 123 124 125 126 127 128 129 130 131 132

Sin comentarios

Brady THT-BP Precision Manual del operador Pagina 127