Brady PAM 3000 Especificaciones descargar pdf (Pagina 11)

11Printer-Applicator-System PAM 3000

5. Unroll a length of label stock from the media roll and feed it first to the printhead (9) as

shown in figure 8.

It is particularly important to ensure that the media strip slides properly through the

fittings of the photocell assembly (10).

6. Feed the label stock out of the side of the printer until there is enough material to reach

the internal rewinder.

7. Take off all labels from the outstanding liner, and feed the liner as shown in figure 8 to

the internal rewinder (12).

8. Slide the media strip under the rewinder clamps (6) to the wind plate. Hold the rewinder

and turn the knurled knob (13) clockwise. That way the label strip will be fixed at the

rewinder.

9. Turn the rewinder (12) clockwise for tightening the label strip.

10. Press the knurled knob (8) upwards to close the transport system.

11. Slide down the guide (11) against the upper edge of the label strip.

Loading Transfer Ribbon

Fig. 9 Loading thermal transfer ribbon

1. Slide the roll of transfer ribbon (4) onto the ribbon supply hub (5) as far as possible.

NOTICE !

Pay attention to the side of the ribbon material which is coated with ink !

The inked side is generally the dull side. When the ribbon is inserted, the

inked side must face the opposite side of the printhead !

2. Hold tight the ribbon supply hub (5) and rotate the knurled knob (6) clockwise until it

stops. That way the transfer ribbon roll (4) will be attached to the ribbon supply hub (5).

3. Slide an empty cardboard core (1) onto the ribbon take up hub (2) and fix it by clockwise

turning the knurled knob (3).

4. Feed the transfer ribbon along the path as shown in figure 9, then attach it to the core

(1) using adhesive tape or a label.

5. Turn take up hub (2) counterclockwise in order to smooth and stretch the ribbon.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Sin comentarios

Brady PAM 3000 Especificaciones Pagina 11