Brady PAM 3000 Especificaciones descargar pdf (Pagina 7)

7Printer-Applicator-System PAM 3000

Mounting the Applicator

1. Put the applicator at the left side of the PAM 3000 printer using the four holes (1).

2. Fasten the applicator by screwing the four screws (8) including the washers.

CAUTION !

Make sure that the two bolts at the rear side of the applicator are inserted

into the long hole (2) and the guide hole (3) on the side of the printer.

Fig. 5 Installing and connecting the applicator

3. Plug the connector of the applicator's electronic system (7) in the peripheral port (4) of

the PAM 3000 printer.

4. Push the compressed air tubes of the applicator (6) into the appropriate push-in-fittings

(5) on the top of the PAM 3000 printer. The appropriate tubes and fittings are marked by

figures.

The lift cylinder is equipped with a slide valve (9), which can only be actuated manually.

By delivering the slide valve is closed. By opening the slide valve (slide the ring

upwards to the position "bleed") it is possible to remove the pad from its upper position

as the compressed air supply is closed and the applicator is switched off.

CAUTION !

Pay attention to the pad while opening the slide valve. It should be swung

away from the peel-off edge of the printer (90°-position).

CAUTION !

The slide valve must be closed during operation. Otherwise the lift

cylinder can be moved without control, which can cause damages.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Sin comentarios

Brady PAM 3000 Especificaciones Pagina 7